Productomschrijving

The AT-VM95C, the new Audio-Technica entry model Conical cartridge replaces the legendary AT90 Series models such as AT91, AT91R and CN5625AL
Also the AT-VM95C is a “budget” cartridge featuring a conical stylus, but thanks to the new VM95 series compatibility you can at any time upgrade to any of the 4 other LP styli of the Series such as Elliptical, Elliptical Nude, Microlinear and Shibata.
Aluminium cantilever
0mV output voltage
Compatible body with all VM95 Series stylus assemblies
Replacement for AT91, AT91R and CN5625AL

Every cartridge diamond stylus becomes worn after a period of play.
Around 500 hours for a conical stylus, 300 hours for an Elliptical stylus, 1000 hours for a Microlinear stylus, and 800 hours for a Shibata stylus.
Our VM95 Series dual moving magnet cartridges can be used almost forever by replacing the interchangeable stylus. It is no longer necessary to purchase a complete cartridge when your diamond is worn out, you can simply buy the matching replacement stylus, but also enjoy the experience of upgrading your cartridge with a different stylus.
The six models of VM95 Series cartridges all use the same electromagnetic engine-body, therefore each of the six replacement styli are perfectly compatible.

This VM95 Series cartridge with 0.6 mil conical stylus fits half-inch mount turntables. The cartridge’s special coil design delivers a powerful output level of 4.0 mV. It also offers excellent channel separation and low distortion for outstanding tonal quality. The durable, low-resonance housing includes threaded inserts that enable the cartridge to be mounted to the headshell with just two screws – no nuts required. And since all VM95 Series share the same body, the stylus can be replaced with any of the six interchangeable AT-VMN95 replacement styli.

Features:
1) VM95 Series dual magnet cartridge with 0.6 mil conical stylus
2) Aluminum cantilever
3) Specially wound coils increase output voltage
4) Durable low-resonance polymer housing
5) Threaded inserts in cartridge body enable cartridge to be mounted to headshell with just two screws – no nuts required
6) Compatible with any AT-VMN95 replacement stylus

SPECS:

Frequency Response: 20-20,000 Hz
Channel Separation: 18 (dB at 1 kHz)
Vertical Tracking Angle: 23°
Vertical Tracking Force: 1.8-2.2 g (2.0 g standard)
Stylus Construction: Bonded round shank
Recommended Load Impedance: 47,000 ohms
Coil Impedance: 3.3 k ohms (1 kHz)
DC Resistance: 485 ohms
Coil Inductance: 550 mH (1 kHz)
Load Capacitance: 100 to 200 pF
Output: 4.0 mV (1 kHz, 5 cm/sec.)
Channel Balance: 2.5 dB (1 kHz)
Stylus Shape: 0.6 mil conical
Cantilever: Aluminum pipe
Mount: Half-inch
Weight: 6.1 g (0.22 oz)
Dimensions: 17.2 mm (0.68") H × 18.9 mm (0.74") W × 28.3 mm (1.20") D
Replacement Stylus: AT-VMN95C
Accessories Included: Two 11 mm installation screws, two 8 mm installation screws, two washers